LK Automation Limited LK Automation Limited
Brand: MITSUBISHI
Go Back >> Product Catalogues
GT27-15PSGC Resist film
MITSUBISHI GT27-15PSGC Manual And Instructions
GT27-15PSGC datasheetPDF datasheet
GT27-15PSGC User's Manual

MITSUBISHI GT27-15PSGC Product information and technical parameters:
Brand: MITSUBISHI
Name: Resist film
Model: GT27-15PSGC
15 inches.
Surface treatment: anti reflective film.
Protective film color: No.
USB protection cover parts: there is an opening.
Set number: 5.
Applicable model: GT27.

Protective film for 5.7 inch screen.
Transparent, 5.
Applicable model: GT14. For the graphic operation terminal on the back of the extra CF port (B disk).
Applicable models: GT16, GT15. Cable length: 3m.
Connection between a connector adapter box and a smart GOT.
Applicable model: HandyGOT. Application: save sampled data, alarm frequency, and alarm records GT27-15PSGC.
The image data is stored in a built-in flash memory and can be maintained even at the end of the battery life GT27-15PSGC
Life expectancy is about 5 years.
Specifications: 850mA 3.6V.
Application Series: F940WGOT, F940GOT. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches GT27-15PSGC.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port GT27-15PSGC.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly. Series Name: A953GOT.
Size: 6 inches.
Resolution: 320 * 240.
Display device: STN monochrome display.
Display color: monochrome (white and black).
Power supply: DC24V.
The built-in RS-232 communication interface.
Memory card: 1M.
Design any machine interface, generally have to consider the system response time, user assistance mechanism, error information processing and command mode four aspects.
System response time is too long to be the most users in the interactive system,
In addition to the absolute length of the response time, the user is also very concerned about the difference in response to different commands in response time,
If too wide users will be difficult to accept; user assistance mechanism should be integrated,
Avoid overlay systems that cause users to turn to a guide and have to browse a large number of irrelevant information;
Error and warning information must bbe selected in terms of user''s clarity and meaning,
At the same time, it should be as far as possible to provide some suggestions on the recovery of errors GT27-15PSGC.
In addition, when the error message is displayed, the effect is better if it iss supplemented by the auditory (Bell) and visual (special color) stimulus;
Command mode is the best menu and keyboard commands, for the user to choose GT27-15PSGC.


...More relevant models >>>>