Memory format: EEPROM.
Number of steps: up to 2000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device.
Note: the built-in program transfer function (FX1S and FX1N host generic). Ethernet.
10BASE-T. Output type: transistor output, drain type.
Output points: 32 points.
OFF leakage current: 0 Q4MCA-8MBS1mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
External connection: 1 wire.
40 pin connector type (FCN connector type).
Through the 40 pin connector type (FCN connector type) can be connected to a variety of devices.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Operation control mode: stored procedure repeated operation.
Input / output points: 4096 points.
Program capacity: 40K.
Programmable controller CPU module through the newly developed control execution engine and high speed system bus,
Can maximize the performance and functionality of the iQ-R MELSEC series.
In addition, by using the motion CPU module of the multi CPU system,
Can achieve high precision motion control.
But also can be used from the computer / computer environment transplant C language controller module has a specific function of CPU.
Program capacity of up to 1200K.
Multi CPU system for high precision motion control.
The built-in CPU module support 2 Gigabit Network port.
Database functions to facilitate data management.
Extended SRAM card with built-in security function.
Can be carried out a variety of motion control (position, speed, torque, advanced synchronous control, etc.).
In line with the international safety standards (13849-1 PL e ISO, IEC 61508 SIL 3) security CPU.
The most suitable for C/C++ language programming from the computer / computer environment for transplantation.
Q4MCA-8MBS Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=Q4MCA-8MBS&select=5